Carbon Express
Carbon Express Maxima RED 5mm Carbon Hunting Shafts, dz.
Carbon Express Maxima RED 5mm Carbon Hunting Shafts, dz.
Couldn't load pickup availability
Sold by the dozen: 12 unfletched carbon hunting shafts.
Carbon Express Maxima RED 5mm shafts pair a small-diameter, high-modulus carbon construction with RED ZONE Tri-Spine Technology to control dynamic flex and help broadheads stabilize quickly. The .204-inch inside diameter provides a balance of penetration, durability, and reduced wind drift. Carbon Express 360-degree spine consistency promotes repeatable shaft behavior and consistent flight.
Features and specifications
- 100% high-modulus carbon construction with RED ZONE Tri-Spine Technology.
- 5mm shaft family with a .204-inch inside diameter.
- Unfletched shafts with Bulldog nock collars and clear LaunchPad Precision nocks. No vanes or feathers.
- Includes 40-grain aluminum sleeved, two-piece insert and outsert components.
- Factory chart: maximum straightness ±.002 inch; average straightness ±.001 inch.
- Weight tolerance: ±1.0 grain.
| Spine | GPI | Factory stock length (in.) | Outside diameter (in.) | Average spine | Insert size | Collar size |
|---|---|---|---|---|---|---|
| 300 | 11.9 | 32.8 | .284 | .263 | #7 | #4 |
| 350 | 10.3 | 32.8 | .275 | .336 | #6 | #4 |
| 400 | 9.4 | 32.8 | .269 | .392 | #5 | #3 |
GPI means shaft weight in grains per inch. Dimensions and average spine values follow the factory Maxima RED 5mm reference chart below.
Matching factory components
- 300 spine: #7 40-grain 5mm insert and outsert (CX0726); #4 Bulldog collar (CX0773).
- 350 spine: #6 40-grain 5mm insert and outsert (CX0725); #4 Bulldog collar (CX0773).
- 400 spine: #5 40-grain 5mm insert and outsert (CX0724); #3 Bulldog collar (CX0772).
- All three spines use the 5mm clear LaunchPad Precision nock (CX0752).
Component part numbers identify the matching factory replacement 12-packs.
Factory reference charts


Factory charts also reference other pack quantities, fletched arrows, or sizes. This listing is for 12 unfletched shafts; only 300, 350, and 400 spine are offered here. Follow the selection chart's point-weight adjustments and guidance.
If having Arrows/Shafts cut, measure from the hole in the nock to the end of the Arrow/Shaft without the insert or point.

Share
